Hybrid Water-Based, Nano-Acrylic Sealer - Soft Sheen Finish



ID: 272

Hybrid is a water-based, nano-acrylic, reactive polyurethane protective treatment for concrete surfaces.  This high-sheen, eco-friendly, single-part sealer provides a very durable, protective barrier from staining substances, makes cleaning far easier.  The Hybrid formula dries quickly and creates a very strong, protective, blush resistant film. Once cured, Hybrid has excellent abrasion and chemical resistance; it also resists rain, UV, oil and grease, household chemicals and from dirt in general. Use for both indoor and outdoor applications.  Can be applied while concrete is still slightly damp (the surface, however, must be fully dry).  Please keep in mind however that no sealer is truly or fully stain resistant. The key to avoiding stains is to clean spills immediately, and that advice extends to all sealers, regardless of manufacturer.

Hybrid is supplied ready to use and should not be diluted.  Container should be shaked vigorously before opening.  Hybrid should not be applied too thickly as this can cause poor adhesion.  It should only be applied when the surfaces are fully dry.  At the very minimum it should be applied in two coats, however, many installers will apply 5-6 thin coats and buff in between.  Apply an even, generous coat sufficient to stay ‘wet’ for 5 - 10 minutes and allow to penetrate the surface.  Top up with additional product in areas that dry out before 10 minutes.  Any excess product should then be removed.  Avoid runs, drips or puddles.

Can be appled using a brush, a high quality - long haired roller or an airless garden sprayer with a fan pattern nozzle.

Each coat should be applied at 90 degrees to the previous layer.  Follow these instructions to the letter or the product will fail!


Supplied in a 1 litre bottle. Coverage 8 - 10 square metres per litre

Best Sellers

Best Sellers


Be the first to review this product

Want to leave a review?

Login Register FREE!